World Shakuhachi Discussion / Go to Live Shakuhachi Chat
You are not logged in.
I've read about something (don't recall the name of it) that builders apply inside the bore to make it more tapered or to "fine-tune" the bore.
Where I live (Sweden) it's next to impossible to get hold of root-end pieces. The only kind of bamboo I can get right now is oil-lamps put on 150 cm bamboo-rods.
Those are great for flutemaking but they are mostly almost straight in the bore.
Is there something I could use to taper the bore so that it will be more in tune in the higher octaves?
What do people use, and how do I get hold of/make it?
regards.
// Chris the Swede.
*** edit ***
Is it called Ji?
Last edited by Toffe (2006-10-07 11:42:59)
Offline
Chris,
Here is a link to some discussion on that topic.
Ken
Offline
Chris - consuder plaster of paris, or "rock hard". I have even used shellac (many coats) to build up a bore. In any case, building a jiari bore shakuhachi is time consuming and will test the patience of the most patient...... consider it a good long tem project.
George
Offline
To see if a taper will have the approximate effect you're looking for, in a cheap and reversible way....
What if you cut/split a dowel of appropriate diameter in half and then tapered it, shaving the flat face down. This could be temporarily slid into the flute and attached maybe against the inner side wall with putty or something to test the effect of a "real" taper...
I know the shape of such an insert would be more crude than a final bore filling, but the tuning effect of reducing the profile area while moving down the flute should be similar, right?
Just thinking out loud; I don't know how well this would work.
-Darren.
Offline